HP Model 715/100 hp 9000 series 700 model 715 workstations service handbook (a - Page 78

Table 4-6. PIM_INFO Action Table Check Type Cache Check Bus Check Word Word Word System Responder Word Action * See Note 1 0x80000000 0x40000000 N/A N/A See Note 2 0x20000000 N/A 0X00210003 0X00000000 Replace SIMM 0xEFFFFFFF See Note 3 0x20000000 N/A 0x00310007 0xF0000000 Replace 0xF7FFFFFF Motherboard 0x20000000 N/A 0x00310007 0xF8000000 0xFBFFFFFF Replace Optional Graphics Card in EISA Slot. 0x20000000 N/A 0x00310007 0xFC000000 See Note 4 0xFFBFDFFF 0x20000000 N/A 0x00310007 0xFFFBE000 See Note 2 0xFFFBEFFF 0x20000000 N/A 0x00310007 0xFFFBF000 Replace 0xFFFFFFFF Motherboard Note 1 When more than one failed FRU is identified, run the appropriate diagnostics to isolate the failed FRU. Note 2 For the Model 715/75, replace the PCX-T module. For other models, replace the Motherboard. See HPMC Caused by a Data Cache Parity Error for more information. Note 3 While Architected Main Memory space is from 0x00000000 through 0xEFFFFFFF, Model 715 can only use up to 256 MB. With this limitation any memory address from 0x10000000 through 0xEFFFFFFF is invalid, and, if given in the System Responder word, the Motherboard should be (usually) replaced. If the error occurs again, there is a probable Kernel problem. See HPMC Caused by a Multi-Bit Memory Parity Error for information on identifying the failed SIMM. Note 4 There are two possible sources of failure. First, replace the EISA controller. If the error occurs again, replace the Motherboard. 4-24 Troubleshooting