HP Model 715/100 hp 9000 series 700 model 715 workstations service handbook (a - Page 103
Front Audio Board Assembly
View all HP Model 715/100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 103 highlights
Front Audio Board Assembly Before removing a front audio board assembly, perform the following steps: S Remove the optional graphics processor (if installed). S Remove the floor stand. S Open the system unit. Unplug the bezel assembly cable from connector P2 on the CPU board. Use a flatblade screwdriver to remove the front audio assembly from inside the system, as shown in Figure 5-16. Figure 5-16. Removing the Front Audio Board Assembly 5-18 Field Replaceable Units
5–18
Field Replaceable Units
Front Audio Board Assembly
Before removing a front audio board assembly, perform the following steps:
S
Remove the optional graphics processor (if installed).
S
Remove the floor stand.
S
Open the system unit.
Unplug the bezel assembly cable from connector P2 on the CPU board. Use a flatblade
screwdriver to remove the front audio assembly from inside the system, as shown in
Figure 5–16.
Figure 5–16.
Removing the Front Audio Board Assembly