HP Model 715/100 hp 9000 series 700 model 715 workstations service handbook (a - Page 94
Disk Drives
View all HP Model 715/100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 94 highlights
Disk Drives Before removing the disk drives, perform the following steps: S Remove the optional external graphics processor (if installed). S Remove the floor stand. S Open the system unit. Disconnect the power cable and the SCSI cable from the disk drive. For CD-ROM drives, disconnect the CD-ROM audio cable. Figure 5-6 through Figure 5-13 show removal and replacement procedures. Refer to the figures that are appropriate for your device. Figure 5-6. Removing the First Hard Disk Drive Field Replaceable Units 5-9
Field Replaceable Units
5–9
Disk Drives
Before removing the disk drives, perform the following steps:
S
Remove the optional
external graphics processor (if installed).
S
Remove the floor stand.
S
Open the system unit.
Disconnect the power cable and the SCSI cable from the disk drive.
For CD–ROM drives, disconnect the CD–ROM audio cable.
Figure 5–6 through Figure 5–13 show removal and replacement procedures. Refer to
the figures that are appropriate for your device.
Figure 5–6.
Removing the First Hard Disk Drive