HP Pro 3500 Maintenance & Service Guide HP Pro 3400, 3405 and 3410 Microto - Page 80
Removing the fan
View all HP Pro 3500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
5. From the inside of the computer, disconnect the cable from the red/brown system board connector labeled SYS_FAN (1), pull the fan into the chassis until it clears the chassis lip, and then lift it out of the chassis (2). NOTE: On some models the connector label is SYS_FAN1. Figure 7-24 Removing the fan To install the fan, reverse the removal procedures. 70 Chapter 7 Removal and Replacement Procedures - Microtower Chassis
5.
From the inside of the computer, disconnect the cable from the red/brown system board
connector labeled SYS_FAN
(1)
, pull the fan into the chassis until it clears the chassis lip, and
then lift it out of the chassis
(2)
.
NOTE:
On some models the connector label is SYS_FAN1.
Figure 7-24
Removing the fan
To install the fan, reverse the removal procedures.
70
Chapter 7
Removal and Replacement Procedures – Microtower Chassis