HP StorageWorks 2/16V HP StorageWorks SAN Switch 2/8V, 2/16V, 2/16N and 4/32 I - Page 108
Table 32 Cabling pinouts, Signal, Description
View all HP StorageWorks 2/16V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 108 highlights
Table 32 describes the cable pinouts. Table 32 Cabling pinouts Pin Signal Description 1 Not supported Not supported 2 RxData Receive data 3 TxData Transmit data 4 Not supported Not supported 5 GND Logic ground 6 Not supported Not supported 7 Not supported Not supported 8 Not supported Not supported 9 Not supported Not supported A 10-foot (3.0-m) serial cable is provided with the switch. It can be converted from a DB-9 serial cable to an RJ-45 serial cable by removing the adapter on the end of the cable. To remove the adapter from the end of the DB-9 serial cable: 1. Ensure the cable and both screws have been disengaged. 2. Pull the adapter straight out, without moving it from side to side, to loosen seating of the connector. If you move the adapter side to side, you might damage the it. CAUTION: When removing the DB-9 male connector from the DTE port, do not use excessive force; otherwise the DB-9 connector will split into two parts easily so that the switch's DTE port is not damaged. 108 SAN Switch technical specifications