HP StorageWorks 2/16V HP StorageWorks SAN Switch 2/8V, 2/16V, 2/16N and 4/32 I - Page 89
Replacing SFPs
View all HP StorageWorks 2/16V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
Replacing SFPs First, use these steps to remove the faulty SFP transceiver. 1. Press and hold the cable release, as shown in Figure 28 on page 90. 2. Remove the cable from the transceiver. 3. Pull the bale (wire handle) to release the transceiver. 4. Grasping it by the bale, gently but firmly pull the transceiver out of the port. CAUTION: If the SFP you are removing does not have a bale, use a small implement such as a screwdriver to press the release trigger beneath the port. Non-baled SFPs can be damaged by the removal process and are not recommended. See "SAN Switch optional kits" on page 28 for a list of supported SFPs. 5. Repeat this procedure for the remaining ports as required. Use these steps to install a replacement SFP. 1. Making sure that the bale (wire handle) is in the unlocked position, and place the SFP in the correctly oriented position on the port, as shown in Figure 28 on page 90. 2. Slide the SFP into the port until you feel it click into place and close the bale. SAN Switch 2/8V, 2/16V, 2/16N and 4/32 installation guide 89