HP StorageWorks 2/16V HP StorageWorks SAN Switch 2/8V, 2/16V, 2/16N and 4/32 I - Page 72
Table 17 SAN Switch 4/32 port side LED patterns during normal operation (continued), LED name
View all HP StorageWorks 2/16V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
Table 17 describes port side LEDs. Table 17 SAN Switch 4/32 port side LED patterns during normal operation LED name LED color Status of hardware Recommended action Power Status No light System is off or there is an internal power supply failure. Verify that system is on. If the system is on, the unit is faulty. Contact HP Technical Support. Steady green System is on and power supplies are functioning properly. No action required. System Status No light System is off, boot is not complete, Verify that system is on and has or boot failed. completed booting. Steady green System is on and power supplies are functioning properly. No action required. Steady amber (for more than five seconds) Boot failed, the system is faulty. Perform the following steps: 1. Connect a serial cable to the system. 2. Reboot the system. 3. Check the failure indicated on the system console. 4. Contact HP Technical Support. Flashing amber/green Attention is required. A number of variables can cause this status including a single power supply failure, a fan failure, or one or more environmental ranges has exceeded. Check the management interface and the error log for details on the cause of status. Contact HP Technical Support if required. Ethernet Speed No light Steady green Port speed is 10 Mb/sec. Port speed is 100 Mb/sec. No action required. No action required. Ethernet Link No light There is no link. Verify that the Ethernet cable is connected correctly. Steady amber There is a link. No action required. Flashing amber/no There is link activity (traffic). light No action required. 72 Managing SAN switches