HP StorageWorks 2/16V HP StorageWorks SAN Switch 2/8V, 2/16V, 2/16N and 4/32 I - Page 36
Installing as a stand-alone device
View all HP StorageWorks 2/16V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Installing as a stand-alone device Follow these steps to install as a stand-alone unit. 1. Unpack the switch and verify that all items listed on "SAN Switch shipping carton contents" on page 32 are present and undamaged. 2. Locate the four rubber feet in the Accessory box. 3. Apply the adhesive rubber feet. Applying the rubber feet in the switch helps prevent the switch from sliding off the supporting surface. a. Clean the indentations at each corner of the bottom of the switch to ensure that they are free of dust or other debris that might lessen the adhesion of the feet. b. With the adhesive side against the chassis, place one rubber foot in each indentation and press into place. 4. Place the switch on a flat, sturdy surface. 5. Apply power to the switch as described in "Powering on and off" on page 62. CAUTION: Do not connect the switch to the network until the IP address is correctly set. For instructions on how to set the IP address, see "Cabling and configuring the SAN Switch" on page 50. 36 Installing and configuring