HP StorageWorks 2/16V HP StorageWorks SAN Switch 2/8V, 2/16V, 2/16N and 4/32 I - Page 37
Installing the switch in a rack using the SAN Switch Rack Mount Kit
View all HP StorageWorks 2/16V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Installing the switch in a rack using the SAN Switch Rack Mount Kit This section provides instructions for installing the SAN Switch in an HP System/e rack, or in an HP 10,000 series rack using the HP StorageWorks SAN Switch Rack Mount Kit supplied with your switch. Install the SAN Switch Rack Mount Kit in one of two ways: • Allow the port side of the switch to slide out of the exhaust-air side of the rack. • In this installation, the port side of the switch is flush with the edge of the rack. • Allow the nonport side of the switch to slide out the cool-air side of the rack. • In this installation, the port side of the switch is set 3 in. (7.62 cm.) back from the edge of the rack, allowing a more gradual bend in the fiber optic cables. NOTE: The SAN Switch Rack Mount Kit install requires one technician. The following items are required to install the switch in a rack: • SAN Switch • Power cables • #2 Phillips screwdriver • 7/16-inch wrench or socket • SAN Switch Rack Mount Kit hardware, illustrated in Table 7 SAN Switch 2/8V, 2/16V, 2/16N and 4/32 installation guide 37