HP StorageWorks 8/80 Brocade Fabric OS Message Reference guide v6.2.0 (53-1001 - Page 100

3 AUTH-1034 Probable Cause Indicates that an entity was not configured in the switch connection control (SCC) policy and tried to connect to the port. Recommended Add the entity's world wide name (WWN) to the SCC policy and reinitialize authentication by using Action the portDisable and portEnable commands or the switchDisable and switchEnable commands. Severity ERROR AUTH-1034 Message , [AUTH-1034], ,, ERROR, , Failed to validate name in : port . Probable Cause Indicates that the specified entity name in the payload is not in the correct format. Recommended Action Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and switchEnable commands. If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity ERROR AUTH-1035 Message , [AUTH-1035], ,, ERROR, , Invalid length in message: length , port . Probable Cause Indicates that a particular data field in the authentication message has an invalid length field. This error usually relates to internal failure. Recommended Action Usually this problem is transient. The authentication might fail. Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and switchEnable commands. If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity ERROR AUTH-1036 Message , [AUTH-1036], ,, ERROR, , Invalid state for : port . Probable Cause Indicates that the switch received an unexpected authentication message. Recommended Action Usually this problem is transient. The authentication might fail. Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and switchEnable commands. 42 Fabric OS Message Reference 53-1001157-01