HP StorageWorks 8/80 Brocade Fabric OS Message Reference guide v6.2.0 (53-1001 - Page 176

17 EM-1058 Probable Cause Indicates the blade is being automatically reset because of known resetable transient errors such as an application-specific integrated circuit (ASIC) parity error. Recommended Action No action is required if the switch does not reach the reset threshold for the switch or blade. If the reset threshold is reached on the switch or blade, the switch or blade will be faulted and should be replaced. Severity WARNING EM-1058 Message , [EM-1058], ,, WARNING, , Switch gets reset: Probable Cause Indicates the switch is being automatically reset because of a known resetable transient problem such as an application-specific integrated circuit (ASIC) parity error. Recommended Action No action is required if the switch does not reach the reset threshold for the switch or blade. If the reset threshold is reached on the switch or blade, the switch or blade will be faulted and should be replaced. Severity WARNING EM-1059 Message , [EM-1059], , FFDC, CRITICAL, , with id cannot be found in the fru description xml file. Probable Cause Indicates that a a blade inserted in the specified slot or the switch (for nonbladed switches) is not compatible with the switch configuration software. The system may not be usable. Recommended Replace the blade. Make sure the replacement is compatible with your switch type. Action Severity CRITICAL EM-1060 Message , [EM-1060], ,, WARNING, , Stopping synchronization of the system due to blade incompatibility with software version on standby CP. Probable Cause Indicates a blade in the system is not supported by the release on the standby control processor (CP). Recommended Action Remove all blades of this type or upgrade your standby CP. Once an appropriate action is taken, this CP must be rebooted or haSyncStart must be run successfully. Until this is done, the system will remain out of synchronization. 118 Fabric OS Message Reference 53-1001157-01