HP StorageWorks 8/80 Brocade Fabric OS Message Reference guide v6.2.0 (53-1001 - Page 561

81 SWCH-1008 Recommended Action Based on the disable reason displayed, proper corrective action may to be required to restore the port. If insufficient frame buffers is the disable reason, reduce the distance or speed settings for the port to reduce the buffer requirement of the link. Alternatively, one or more ports in the port group must be disabled to make more buffers available for the link. Please refer to the Fabric OS Administrator's Guide for more information about buffers. Severity WARNING SWCH-1008 Message , [SWCH-1008], ,, WARNING, , are port swapped on ports that do not support port swap. Slot will be faulted. Probable Cause Indicates the blade is enabled with the port configuration that already has area swapped. Recommended Action Replace the blade with ports that support port swap. Then port swap the ports back to ports default area. Refer to the Fabric OS Administrator's Guide for more information on port swapping. Severity WARNING SWCH-1009 Message , [SWCH-1009], ,, WARNING, , Shared area having Trunk Area (TA) enabled on slot . Shared areas that have TA enabled will be persistenly disabled. Probable Cause Indicates the blade is enabled with a port configuration that had Trunk Area enabled on shared area port previously. Recommended Action You must disable Trunk Area on ports that had Trunk Area enabled previously. Refer to the Fabric OS Administrator's Guide for more information. Severity WARNING SWCH-1010 Message , [SWCH-1010], ,, WARNING, , Trunk Area (TA) enabled on slot with switch not in PID format 1. TA enabled ports will be persistently disabled. Probable Cause Indicates the blade is enabled with the port configuration that had Trunk Area enabled previously. Recommended Action You must disable Trunk Area on ports that had Trunk Area enabled previously. Refer to the Fabric OS Administrator's Guide for more information. Fabric OS Message Reference 503 53-1001157-01