HP StorageWorks 8/80 Brocade Fabric OS Message Reference guide v6.2.0 (53-1001 - Page 219

27 FCR-1018 FCR-1018 Message , [FCR-1018], ,, ERROR, , FC router proxy device entries exhausted on port . Probable Cause Indicates that the number of proxy devices is greater than allowed by the port resource. Recommended Action Remove excess logical storage area network (LSAN) zones or devices until the number of proxy devices exported is within the range allowed by the port resource. Use the fcrResourceShow command to view resources including LSAN zone resources, LSAN device resources, and proxy device port resources. Use the fcrProxyDevShow command to view how many proxy devices are created in the fabric with the port resource problem. LSAN zones are removed using standard zoning commands such as zoneShow, zoneRemove, zoneDelete, cfgDelete, and cfgDisable in the edge fabric. Proxy devices can be removed by zoning operations or by bringing physical devices offline. For example, disabling the port that a device is attached to, and then disconnecting the cable or disabling the device. Severity ERROR FCR-1019 Message , [FCR-1019], ,, ERROR, , EX or VEX port entries exhausted at port . Probable Cause Indicates that the number of EX_Port or VEX_Port entries being created is greater than allowed by the port resource. Recommended EX_Port or VEX_Ports exceeding the range allowed by the port resource will be automatically Action disabled. Use the fcrRouteShow command to display the NR_Port limits. Severity ERROR FCR-1020 Message Probable Cause Recommended Action , [FCR-1020], ,, WARNING, , Local LSAN zone entries for FC router exhausted; max limit: . Indicates that the number of logical storage area network (LSAN) zones created within a MetaSAN exceeds the local LSAN zone database limitations. Remove excess LSAN zones so that the number of LSAN zones created is within the range of local database limitations. To do that, perform the following steps: 1. Run portDisable to disable all the EX_Ports that got this error message. 2. Run portDisable to disable all the other EX_Ports on that FCR connected to the same edge fabrics the EX_ports disabled in step 1 are connected to. Fabric OS Message Reference 161 53-1001157-01