HP Surestore Disk Array FC60 HP SureStore E Disk Array FC60 Service Manual (A5 - Page 363

Managing the Disk Array on HP-UX Status AM60: OPTIMAL STM: OPTIMAL (OPT) AM60: NON-EXISTENT STM: No Disk (NIN) AM60: UNASSIGNED STM: OPTIMAL (OPT) AM60: FAILED--CAUSE UNKNOWN STM: FLT - 3 AM60: REPLACED STM: OFF - 4 AM60: WRONG DRIVE REMOVED OR REPLACED STM: FLT - 9 AM60: OFFLINE-INTERNALLY MARKED OUT OF SERVICE STM: OFF - 11 Definition/Action The disk is operating normally. No action is required. The disk array controller has no knowledge of a disk in this slot. This may be caused by no disk being installed, or a disk that never responds to a SCSI command from the controller. No action is required. The disk is a member of the unassigned disk group. It is available for use in a LUN or as a hot spare. No action is required. The disk has failed due to an unknown condition. Replace the disk. The disk has been replaced. The disk will maintain this status until the original data has been rebuilt or copied to the disk. No action is required. The wrong disk was removed or replaced from a degraded LUN. The new disk gets this status. Reinstall the original disk. A disk has been installed that was part of another LUN, possibly in another disk array. The disk array attempts to recreate the original LUN, but because some of the disk are missing, the disk is marked OFFLINE. The newly created LUN will also be assigned a status of DEAD. Unbind the LUN the disk array has created. This will return the disk to UNASSIGNED status. AM60: NON-SUPPORTED CHANNEL STM: FLT - 17 The command issued specified an invalid channel. Retry the command using the proper channel. 363