HP rp7440 User Service Guide, Fourth Edition - HP Integrity rx7640 and HP 9000 - Page 154
Removing a Rear Smart Fan Assembly, Removing and Replacing a Disk Drive
View all HP rp7440 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 154 highlights
Removing a Rear Smart Fan Assembly Figure 6-13 Rear Fan Detail 1. Pull the fan release pin upward away from the fan. 2. Slide the fan away from the connector. 3. Pull the fan away from the chassis. Replacing a Rear Smart Fan Assembly 1. Carefully position the fan assembly on the chassis fan guide pins. 2. Slide the fan into the connector. 3. Verify that the fan release pin is in the locked position. NOTE: A green fan LED indicates the fan is operational. Removing and Replacing a Disk Drive The disk drives are located in the front of the chassis. The nPartition must be shut down to remove or replace the drive that serves as the boot disk, if the boot disk is not mirrored. Refer to "Powering Off Hardware Components and Powering On the Server" (page 142) for more information. The remainder of the internal disk drives are hot-pluggable. 154 Removing and Replacing Components