Hitachi DZ-BD70AF Owners Guide - Page 148
Quick Start
UPC - 050585224094
View all Hitachi DZ-BD70AF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 148 highlights
Symptom Cause and Correction Reference page The remote control Do you operate the remote control toward the remote does not operate. control receiver of the camcorder? 16 If the camcorder's remote control receiver is exposed to strong light such as direct sunshine or fluorescent light, the remote control does not work. - Adjust the position or angle of the camcorder. Is the lithium battery inserted in the remote control? Check that the polarization of the lithium battery is correctly set. 17 The lithium battery may be empty. Replace the battery to a new one. Is the camcorder powered on? If not, turn on the camcorder. 22 Disc cover cannot be Is the disc correctly inserted? closed. Remove the disc and then reinsert it. 33 Connect a fully charged battery or AC adapter/charger, and then turn the camcorder on and try again. 21, 37 Operating noise is This is not a fault. A quiet operating sound is heard as the heard. disc rotates during recording or playback, etc. - Some vibrations are These vibrations or sound are caused by HDD/disc drive. felt or slight sound is This does not indicate a fault. heard from - mechanism. • No operation can In the following cases, it will take more time than usual be performed until operation is possible: because the • Immediately after a disc or card is inserted. ACCESS/PC or • When a long time has elapsed since the camcorder was CARD ACCESS turned off last. indicator on this • When the temperature is greatly different from the camcorder remains status of previous recording. - lit or flashing. • When a scratched or dirty disc is inserted. • After a disc or • When the camcorder is subjected to strong vibrations. card is inserted, it • When the battery or DC power cord was disconnected takes some time before turning the power switch off. until recording is possible. No image in the viewfinder. • Is the LCD monitor open? No image will appear in the viewfinder unless the LCD monitor is closed (default setting). You can change this setting. • Is the camcorder set to the sleep mode? Press QUICK START to release sleep mode. 20, 40 Additional Information 148