Intel SBXD132 User Guide - Page 27
Removing the Blade Server Bezel Assembly, Installation Guidelines on,
UPC - 735858189408
View all Intel SBXD132 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
b. Use the extraction device on the expansion unit, if one is present, to disengage the expansion unit from the system board. These extraction devices can be of several types, including thumb screws or levers. c. Rotate the expansion unit open, as shown in the illustration; then, lift the expansion unit from the blade server. Removing the Blade Server Bezel Assembly To install certain options, you must first remove the blade server bezel assembly. The following illustration shows how to remove the bezel assembly. Bezel-assembly release (both sides) Control-Panel Cable Bezel Control-panel connector AF000933 To remove the blade server bezel assembly, complete the following steps: 1. Read the safety information beginning on page vii and "Installation Guidelines" on page 15. 2. Open the blade server cover (see "Opening the Blade Server Cover" on page 17 for instructions). 3. Press the bezel-assembly release and pull the bezel assembly away from the blade server approximately 1.2 cm (0.5 inch). 4. Disconnect the control-panel cable from the control-panel connector. 5. Pull the bezel assembly away from the blade server. 6. Store the bezel assembly in a safe place. Intel® Server Compute Blade SBXD132 Installation and User's Guide 19