Intel SBXD132 User Guide - Page 34

7. Remove the two screws that secure the heat-sink filler and then remove the filler from the microprocessor socket. Install the microprocessor: Caution: Do not touch the pins in the microprocessor socket. Touching these pins might result in permanent damage to the system board. Microprocessor dust cover Microprocessor release lever a. Remove the protective cover from the microprocessor retainer, if one is present. Caution: Do not use any tools or sharp objects to lift the locking lever on the microprocessor socket. Doing so might result in permanent damage to the system board. b. Rotate the locking lever on the microprocessor socket from its closed and locked position until it stops in the fully open position (approximately a 135° angle), as shown. c. Rotate the microprocessor retainer on the microprocessor socket from its closed position until it stops in the fully open position (approximately a 135° angle), as shown. d. Touch the static-protective package that contains the new microprocessor to any unpainted metal surface on the blade server or any unpainted metal surface on any other grounded rack component in the rack you are installing the microprocessor in for at least 2 seconds; then, remove the microprocessor from the package. e. Remove the cover from the bottom of the microprocessor. Microprocessor Alignment marks Microprocessor socket 26 Intel® Server Compute Blade SBXD132 Installation and User's Guide