JVC BR-DV6000U User Manual - Page 14

NAMES AND FUNCTIONS OF PARTS $% * ^ & - Front panel - (continued) # Mini MENU DISP RESET SEARCH- SET SEARCH+ MIC HOLD BLANK CUE UP PHONES REC LEVEL CH-1/3 CH-2/4 PROFESSIONAL BR-DV6000 OPERATE A.DUB REC PLAY PAUSE EJECT REW STOP FF AUDIO INPUT COUNTER MONITOR OUTPUT SELECT CTL L CH-1/2 DV TC MIX MIX LINE UB R CH-3/4 Y/C (CPN) REMOTE LOCAL !@ 0 0 [REC LEVEL] Volume for audio recording level for CH1/3 and CH2/4 Use the switch to adjust the audio recording level for CH1 and CH2. During audio dubbing, the audio recording level for CH3 and CH4 can be adjusted with this switch. Memo ● During DV input, the volume control is not effective. ● During MIC input, only the volume for CH1/3 REC LEVEL is valid. ! [PHONES] terminal This is the mini jack terminal for connecting to the headphone. (Stereo ø3.5) • When BR-DV6000 plays back tapes recorded in the 32 kHz mode, the audio channel for outputting from this terminal is selected with the 6 AUDIO OUTPUT switch. @ [PHONES] Headphone volume Use this switch to adjust the output level of the PHONES terminal. Both channels are adjusted at the same time. # [MIC] terminal This is the mini jack terminal for monaural microphone input. To input sound from a microphone, set the [INPUT SELECT] switch to LINE or Y/C (CPN). If a microphone is connected, sound for the AUDIO IN terminal located on the rear panel cannot be input. The sound of the microphone is recorded to CH1/CH2 in the recording mode and CH3/CH4 in the audio-dubbing mode. 14 $ [HOLD] button If this button is pressed in the LCD enlarged display mode, the time code preset screen will be displayed on the LCD. When the time code preset screen is displayed, press this button to return to the normal display. (☞ Page 59 "Presetting time code") % [MENU] button If this button is pressed when BR-DV6000 is in the STOP/STILL mode or when no cassette is loaded, the menu is displayed on the LCD or the monitor connected to the VIDEO MONITOR OUT terminal. When the menu is displayed, press this button to return to the normal display. (☞ Page 70 "Setting the menu") ^ [RESET] button • To reset the CTL counter display to "00", press this button. • If this button is pressed when the time code preset screen is displayed, all the digits of the time code or the user's bit are reset to "00". • When the Multi Cue-up screen is displayed, press this button to clear the registered cueup points. & [CUE UP] button When the 8 COUNTER switch is set to TC, press this button to display the Multi Cue-up screen on the monitor or LCD. When the Multi-Cue-up screen is displayed, press this button to start searching the selected tape position. (☞ Page 54 "Multi Cue-up")