JVC BR-DV6000U User Manual - Page 87

Table J1 J1 B J1 Command Description B0 VISS FORWARD : Index search in the forward direction. For the index search position, enter a 3-digit number (001-099) following the command. When a 3-digit number has been entered, index search starts. If ENTER (40H) is transmitted before all three digits are entered, the remaining digit(s) are considered as "0" (30H), and index search starts. B1 VISS REV : Index search in the reverse direction. For the index search position, enter a 3-digit number (001-099) following the command. When a 3-digit number has been entered, index search starts. If ENTER (40H) is transmitted before all three digits are entered, the remaining digit(s) are considered as "0" (30H), and index search starts. B2 CUE UP WITH DATA : Use this command to cue up a specified point on the tape. When the tape is cued, COMPLETION is returned and the Pause mode becomes effective. To specify a cue point, transmit the time data (hour: minute: second: frame, a total of 8 bytes with 2 bytes for each) following this command. By transmitting ENTER (40H) with the time data, transmission of lower data becomes unnecessary. In such a case, "0" is transmitted. If the specified point cannot be found, NOT TARGET (05H) is returned. B2 CUE UP AND PLAY WITH DATA: Use this command to cue up a specified point on the tape. When the tape is cued, COMPLETION is returned and the Play mode becomes effective. To specify a cue point, transmit the time data (hour: minute: second: frame, a total of 8 bytes with 2 bytes for each) following this command. By transmitting ENTER (40H) with the time data, transmission of lower data becomes unnecessary. In such a case, "0" is transmitted. If the specified point cannot be found, NOT TARGET (05H) is returned. Table J1 Command Description B5 F-SHUTTLE : Shuttle play. The search speed is specified by sending the speed code data after this command (see the table below). Speed code table (Supported speed only) Speed code Search speed 30h STILL 31h 0.1 32h 0.2 33h 0.33 34h 0.5 35h 1 36h 2 37h 5 38h 10 39h 20 3Bh X0.90 3Ch X1.07 3Bh and 3Ch are effective only for B5. B6 R-SHUTTLE : Shuttle reverse play. The search speed is specified by sending the speed code data after this command (see the ta- ble above). B CO AUTO EDIT KEY : Audio editing with the VCR. • It is required that the editing chan- nel is selected in [E5: Edit Preset]. • This audio editing command must be used with [FA: Rec Request]. • Preroll time can be set with [E6: Preroll Time Preset]. Without this setting, the VCR menu switch set- tings are followed. • Upon the completion of auto editing, the VCR returns [01: Complete]. B C1 PREVIEW KEY : Preview with the VCR • It is required that the editing chan- nel is selected in [E5: Edit Preset]. • This preview command must be used with [FA: Rec Request]. • Preroll time can be set with [E6: Preroll Time Preset]. Without this setting, the VCR menu switch set- tings are followed. • Upon the completion of preview, the VCR returns [01: Complete]. 87