JVC BR-DV6000U User Manual - Page 31
AUDIO MONITOR switches and output, channels of AUDIO OUTPUT/PHONES, Input signal
UPC - 046838325557
View all JVC BR-DV6000U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
● Connecting to a monitor TV A monitor TV can be connected to the AUDIO MONITOR OUT terminal. The sound output from the AUDIO MONITOR OUT terminal is monaural. • The volume is adjusted through the monitor TV. • The output channel can be selected with the AUDIO MONITOR switch on the front panel (Refer to the following table). AUDIO MONITOR switches and output channels of AUDIO OUTPUT/PHONES In the following cases, the output channels from the AUDIO MONITOR OUTPUT/PHONES terminal vary according to the setting of the AUDIO MONITOR switch and the AUDIO OUTPUT switch. The table below shows the channels. • During playback of tapes recorded in the 32kHz audio mode. • During audio dubbing. • In the EE mode of DV input in the 32 kHz audio mode. AUDIO switch MONITOR OUTPUT CH1/2 L MIX CH3/4 CH1/2 MIX MIX CH3/4 CH1/2 R MIX CH3/4 MONITOR OUT/ PHONES terminal CH1 CH1/3 CH3 CH1/2 CH1/2/3/4 CH3/4 CH2 CH2/4 CH4 • In the 48kHz audio mode or during normal recording, it outputs to CH1/2 channel (the OUTPUT switch listed in the above table shows the setting of CH1/2). • When MIX is selected, the PHONES terminal outputs stereo sound. ● Digital output IEEE1394-compliant digital signals are output from the DV IN/OUT terminal. Ⅵ Input signal ● Analog signal CH 1/3 AUDIO IN terminal. (RCAן2) There are analog input terminals for 2 channels. Recording cannot be performed to 4 channels at the same time. Sound from each terminal is usually recorded to CH1 and CH2. To record to CH 3 and CH 4, set AUDIO MODE of the AUDIO Menu screen to 32 k and record it in the audio-dubbing mode. (☞ Page 44) ● Microphone input terminal This terminal is for connecting to a monaural microphone. The same sound is recorded on the 2 channels. Memo ● To record sound on the AUDIO IN terminal and MIC terminal, set the INPUT SELECT switch on the front panel to "LINE" or "Y/C (CPN)". ● If the AUDIO IN terminal and MIC terminal are used at the same time, the MIC terminal precedes. ● Digital input IEEE1394-compliant digital signals are input into the DV IN/OUT terminal. • To enable audio input into this terminal, set the INPUT SELECT switch to DV. • The AUDIO MODE (48 K or 32 K) will be one of input signals. • During digital signal input, the recording level cannot be adjusted. Memo ● An input/output board (sold separately) of the XLR connector can be installed in the optional slot. SA-X61U AUDIO XLR IN board SA-X62U AUDIO XLR OUT board These boards cannot be installed at the same time. ● For BR-DV600 player, when the mode is changed from STILL to PLAY, sound will be muted for a while shortly after the audio output. Thereafter, it will resume as per normal. (This does not occur with BR-DV600A.) 31