JVC BR-DV6000U User Manual - Page 90

RS-232C INTERFACE - RS-232C commands - (continued) Ⅵ D7: STATUS SENSE This section describes 5-byte data that are returned when the STATUS SENSE (D7H) command is sent. ● First byte Bit No. Status: If the bit is 1 7 Always 1 6 Always 0 5 SHORT FF/REW : In short FF or short REW 4 REC INHIBIT : Recording prohibited 3 CASSETTE OUT : No cassette tape loaded 2 SERO LOCK : Servo locked 1 Undefined : Always 0 0 ERROR : Error occurring ● Second byte Bit No. 7 6 5 4 3 2 1 0 Status: If the bit is 1 VIDEO EE AUD EE VIDEO MUTE AUD MUTE WARNING DEW TAPE BEGIN TAPE END : Video output in the EE mode : Audio 1 output in the EE mode : Video signals muted : Audio signals muted : Problem with the VCR : Condensation in the VCR : Short FF at the tape beginning. : Short REW at the tape end ● Third byte Bit No. 7 6 5 4 3 2 1 0 Status: If the bit is 1 TIMER PLAY TIMER REC Unused REPEAT Unused REPEAT MODE SEARCH MODE Unused : TIMER switch set to PLAY : TIMER switch set to REC : Always 0 : REPEAT PLAYBACK mode ON : Always 0 : Repeat playback in operation : VCR being cueing-up/prerolling : Always 0 ● Fourth byte Bit No. Status: If the bit is 1 7 PLAY MODE : VCR playing 6 FF MODE : VCR fast-forwarding 5 REW MODE : VCR rewinding 4 STOP MODE : VCR stopped 3 STAND BY MODE : VCR on standby 2 EJECT : Cassette tape being ejected 1 REC MODE : VCR recording 0 ADB MODE : VCR audio dubbing ● Fifth byte Bit No. Status: If the bit is 1 7 PAUSE MODE : VCR paused 6 Unused : Always 0 5 SHUTTLE FWD : VCR forward shuttle-searching 4 SHUTTLE REV : VCR reverse shuttle-searching 3 SPEED CODE3 : Refer to the following table. 2 SPEED CODE2 : Refer to the following table. 1 SPEED CODE1 : Refer to the following table. 0 SPEED CODE0 : Refer to the following table. Search speed table (Supported speed only) Search speed STILL 0.1 0.2 Speed code (Bit No.) 3 2 1 0 0 0 0 0 0 0 0 1 0 0 1 0 0.3 0 0 1 1 0.5 0 1 0 0 1 2 5 9 (10) 20 0 1 0 1 0 1 1 0 0 1 1 1 1 0 0 0 1 0 0 1 ( ): PAL 90