Kyocera FS 1900 Operation Guide - Page 120
Others, >Auto Continue>, >>Auto Continue, Timer, Setting the Auto Continue Recovery Time
UPC - 783310458241
View all Kyocera FS 1900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 120 highlights
Configuration Setting the Auto Continue Recovery Time Follow the procedure given below to change the recovery time for Auto Continue. 1 Press the MENU key. 2 Press the or key repeatedly until Others > appears. Others > 3 Press the > key. 4 Press the or key repeatedly until Auto Continue Mode > appears. >Auto Continue > Mode On 5 Press the > key and display >>Auto Continue Timer. 6 Press the ENTER key. A blinking cursor ( ) appears. >>Auto Continue Timer 000Sec. 7 Press the or key to increase or decrease the value of the figure where the cursor is blinking and set the desired time. The time must be set between 000 and 495 seconds, in 5-second increments. If set to 000, printing will be continued immediately without allowing any time interval. You can use the > and < keys to move the cursor right and left. 8 Display the desired time and press the ENTER key. 9 Press the MENU key. The message display returns to Ready. 1-106