Kyocera FS 1900 Operation Guide - Page 154
Error Messages, Auto Continue Setting, Formatting a Storage Device
UPC - 783310458241
View all Kyocera FS 1900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 154 highlights
Indicators and Messages Error Messages The following table lists error messages that can be dealt with by the user. Message Corrective Action File not found Press GO VMB: A VMB tray that was specified for output does not contain any jobs, or the VMB tray is not being used. Confirm the VMB tray. If Auto Continue is set to On, printing will be automatically resumed after a preset ;Òperiod of time. See Auto Continue Setting on page 1-105. Format error Memory card This message appears when the printer is in the ready state and the CompactFlash (memory) card is not formatted, and therefore cannot be read or written. Follow the procedure in Formatting a Storage Device on page 1-88 to format the card. Format error Hard disk Initialization (formatting) of the Microdrive is required. Initialize the Microdrive. (See Operating the Storage Device on page 1-81.) Hard disk err ## Press GO Look at the error code given in place of ## and refer to the corresponding description given below. 01: Microdrive format error. If this error recurs even if the power has been turned off and then on, reformat the Microdrive. 02: The disk system is not installed. Recheck the requirements for using the system and the devices. 04: There is no available Microdrive space. Delete unnecessary files, etc., in order to free up space. 05: The specified file does not exist in the Microdrive. 06: There is no memory available to the Microdrive system. Increase the available memory. 10: Formatting is not possible because host data is being spooled on the Microdrive. Wait until the Microdrive is ready, and then format. 85: VMB; Alias error (the alias setting was lost, or the VMB tray corresponding to the alias does not exist). Set the alias again. 97: Code job; The number of permanent code job reached the limit value, and no more can be saved. Either delete some unnecessary jobs, etc., or increace the limit. ;Ò99: A print job for the specified ID does not exist in the Microdrive. I/F occupied This message is displayed when you attempt to use the printer's operator panel to change the environmental settings on the interface from which data are presently being received. ID error The ID entered for a private job, or a stored job is not correct. Check the ID that is set using the printer driver. Insert the same memory card You have inserted the wrong CompactFlash (memory) card when the Insert again message was displayed. Remove the wrong CompactFlash card from the printer's CompactFlash card slot and insert the correct CompactFlash card. The printer again reads it from the beginning of the data. KPDL error ## Press GO Current print processing cannot continue. To print out an error report, display > Print KPDL errs from the mode select menu, and select On. Press the GO key to resume printing. You can abandon printing by the CANCEL key. If Auto Continue is set to On, printing will be automatically resumed after a preset ;Òperiod of time. See Auto Continue Setting on page 1-105. ;Ò:Alarm buzzer sounds when an error occurs. Press the CANCEL key to stop the alarm buzzer. (Continued on next page) 4-10