Kyocera FS 1900 Operation Guide - Page 88
Interface, Parallel Interface Mode, Parallel
UPC - 783310458241
View all Kyocera FS 1900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
Interface Interface The printer is equipped with both a parallel and USB interface. Option serial interface board kit and network interface card can also be installed. Various printing environment parameters such as the default emulation can be changed indepently on different interfaces by using the printer's menu selection system. Before select the interface to apply the changes in the procedure described below. This interface selection described below does not select which interface data will be received from. The printer automatically selects an interface Note data is received. Parallel Interface Mode The parallel interface mode of this printer supports a bi-directional/highspeed mode. Normally, this interface is used under the default setting AUTO. For details, see Appendix C. After setting the interface, be sure to reset the printer or turn the power off at least once. The new setting will be enabled thereafter. 1 Press the MENU key. 2 Press the or key repeatedly until Interface > appears. One of the interface names shown below appears, indicating the current interface. Parallel (default) USB Serial (when a serial interface board kit is installed) Option (when a network interface card is installed) 3 Press the ENTER key. A blinking question mark (?) appears. Interface ? Parallel If Parallel is not displayed, press the or key repeatedly until it is Parallel. If you want to abandon the interface selection procedure, press the CANCEL key. The interface remains unchanged. 4 Press the ENTER key again. 5 Press the > key. The message display changes to the communication mode menu. 1-74