Lexmark 2380 Service Manual - Page 87
Repair Information 4-13, Perform the Printhead-to-Platen Gap Adjustment
View all Lexmark 2380 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 87 highlights
10. Release the ground spring [11] from the end of the carrier shaft; the spring need not be removed. 11. Rotate the left carrier bushing. 12. Remove the lever stop bracket from the carrier motor (bracket not present on all machines). 13. Release the latch [8] and slide the carrier shaft and forms thickness lever to the left and remove them together from the printer. Do not to lose the gap set collar [15] attached to the right end of the carrier shaft. 14. Lift the rear of the carrier [12] to disengage the carrier ribbon drive gears, then remove the carrier. Do not to lose the oil felt [14]. 15. Be sure to get the carrier shaft correctly through the oil felt. 16. Perform the Printhead-to-Platen Gap Adjustment see "Printhead-to-Platen Gap Adjustment" on page 4-2. Repair Information 4-13