Lexmark C530DN Technical Reference - Page 72

2-60 PCL Note: For the commands listed in Table 2-19, font selection is based on all parameters set following the best fit selection rules. Table 2-19: Font Selection Command / Parameters ESC(# (primary) ESC)# (secondary) # = symbol set ID Default = 10U (PC-8) or 12U (PC-850), [Country specific] ESC(s#P (primary) ESC)s#P (secondary) 0 Fixed (Default) 1 Proportional ESC(s#H (primary) ESC)s#H (secondary) # = characters per inch Default = 10 ESC(s#V (primary) ESC)s#V (secondary) # = height in points (.25 to 999.75) Default = 12 ESC(s#S (primary) ESC)s#S (secondary) 0 Upright (Default) 1 Italic 4 Condensed 5 Condensed Italic 8 Compressed 24 Expanded 32 Outline 64 Inline 128 Shadowed 160 Outline Shadowed Function / Result Select Symbol Set The line-draw characters are contained in the symbol set ID 10U, PC-8. The non-U.S. characters are contained in symbol set ID 12U, PC-850. Select Spacing Selects a font with proportional or fixed spacing. Select Pitch Selects the number of characters per inch (cpi) for a fixed-space bitmapped or monospaced scalable font. Valid to 2 decimal places. Note: Pitch is not needed for proportional spaced fonts. Height (Select Point Size) Sets the font height in points. Valid to 2 decimal places. Note: Point size is not needed for monospaced fonts. For fonts larger than 12 points, it may be necessary to change the line spacing. Select Style Identifies the physical traits of a character and the composition of the font symbols. Note: You can only use this command to select fonts currently available in the printer. It cannot alter the appearance of the available fonts.