Lexmark T642 Menus and Messages - Page 12

Using printer menus Menu selection Purpose Values Card Stock Loading Properly handles preprinted card Duplex stock whether the job is a duplexed or single-sided job. Off* Custom Loading Properly handles preprinted Duplex custom paper whether the job is a duplexed or single-sided job. Off* Shown if Card Stock is supported in the specified input source. Shown if the custom type is supported in the specified input source. Custom Types This menu selection is used to define a name for each custom paper type. You can assign names using a utility such as MarkVision or from the operator panel. Menu selection Custom Type N Purpose Specifies the type of paper associated with each Custom Type available in the Paper Type menu. Values Paper* Card Stock Transparency Labels Vinyl Labels Envelope The custom type media must be supported in the input source you designate in order to assign a userdefined name. Once the name is assigned, the name (truncated to 16 characters) will be displayed instead of Custom Type x. Universal Setup This menu selection is used to specify the height and width of the Universal Paper Size. By specifying the height and width for Universal Paper Size, the printer will use the Universal setting exactly like other paper sizes, including support for duplex and n-up. Menu selection Units of Measure Portrait Width Portrait Height Feed Direction Purpose Values Determines the unit of measure used to enter the Universal Height and Width. Inches Millimeters Inches is US default; Millimeters is international default. Sets the portrait width of the universal media. Note: If the value set exceeds the maximum width, the printer will use the maximum value allowed in inches or millimeters. 3 inches to 14.17 inches in 0.01 inch increments 76 mm to 360 mm in 1 mm increments Shows either inches or mm from Units of Measure setting; 8.5 inches is the US default, and 216 mm is the international default. Sets the portrait height of the universal media. Note: If the value set exceeds the maximum height, the printer will use the maximum value allowed in inches or millimeters. 3 inches to 14.17 inches in 0.01 inch increments 76 mm to 360 in 1 mm increments Shows either inches or mm from Units of Measure setting; 14 inches US default, 356 international default. Specifies the feed direction of Short Edge* the Universal Paper Size. Long Edge Long Edge is only shown if the longest edge is shorter than the Maximum Physical Width of the printer. 12