Lexmark T642 Menus and Messages - Page 17

Using printer menus Menu selection Power Saver Purpose Specifies the amount of time (in minutes) the printer waits after a job is printed before it goes into a reduced power state. Values Disabled 1...240 Alarms Controls whether the printer sounds an alarm when the printer requires operator intervention. Alarm Control: Off Single* Continuous Toner Alarm: Off* Single Continuous Staple Alarm: Off* Single Continuous This value does not appear unless Energy Conserve is set to Off. See the User's Guide for more information. Specifies the amount of time after a print job before the printer goes into Power Saver mode. (Your printer may not support the entire range of values.) The factory default Power Saver setting depends on your printer model. Print the menu settings page to determine the current Power Saver setting. When the printer is in Power Saver mode, it is still ready to receive print jobs. Select 1 to put the printer in Power Saver mode one minute after it finishes a print job. This uses much less energy, but requires more warm-up time for the printer. Select 1 if your printer shares an electrical circuit with room lighting and you notice lights flickering. Select a high value if your printer is in constant use. Under most circumstances, this keeps the printer ready to print with minimum warm-up time. Select a value between 1 and 240 minutes if you want a balance between energy consumption and a shorter warm-up period. Off-Printer does not sound an alarm. Single*-Printer sounds three quick beeps. Continuous-Printer repeats three beeps every 10 seconds. Note: Staple and hole punch alarms appear only when an optional finisher is installed. 17