Lexmark T642 Menus and Messages - Page 44
Reading USB drive DO NOT REMOVE, Port disabled Remove USB drive
UPC - 734646722001
View all Lexmark T642 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Understanding printer messages Message Action Network , A network interface is the active communication link, where represents the active communication link, and represents the channel. No held jobs Wait for the message to clear. No jobs found Note: The four-digit personal identification number (PIN) you entered is not associated with any confidential print job. • Select Try again to enter another PIN. • Select Cancel to exit the Enter PIN screen. No jobs to cancel Wait for the message to clear. No recognized file types Wait for the message to clear. Note: The only supported file type is PDF. Overflow Bin Full Remove the stack of paper from the bin to clear the message. Parallel A parallel interface is the active communication link. Parallel Port disabled Remove USB drive Wait for the message to clear. Power Saver • Send a job to print. • Press to warm the printer to normal operating temperature and display the Ready message. Printer locked, enter PIN to unlock The operator panel has been locked. Enter the correct PIN number. Printing Wait for the message to clear. Printing Alignment Page Wait for the message to clear. Printing from USB drive DO NOT REMOVE Warning: Do not turn the printer off or remove the USB drive while this message is displayed. Wait for the message to clear. Printer busy Continue Quit Press to read the information from the USB drive. Select Quit to cancel the information retrieval process. Programming System Code Warning: Do not turn the printer off while this message is displayed. Wait for the message to clear and the printer to reset. Programming Flash Warning: Do not turn the printer off while this message is displayed. Wait for the message to clear. Programming Disk Warning: Do not turn the printer off while this message is displayed. Wait for the message to clear. Reading USB drive DO NOT REMOVE Wait for the message to clear. Ready Send a job to print. Reattach bin • Turn the printer off and back on. - If the error recurs, turn the printer off, unplug the power cord from the wall outlet, and remove the specified bin, then reattach the bin to the printer, reconnect the power cord to a properly grounded outlet, and then restart the printer. - If the error recurs, turn the printer off, unplug the power cord from the wall outlet, and remove the specified device, and call for service. • Press to clear the message and print without using the specified bin. 44