Marantz SR5002 SR4002_Rear_Panel_Drawing - Page 11

ENGLISH REAR PANEL (SR4002) w !1 qt r !3 !6 VIDEO INPUT 1 FM (75) GND AM ANTENNA L SL C L S-VIDEO TV SBL DVD VCR IN VCR OUT DSS INPUT MONITOR OUT 2 Y CB/PB CR/PR INPUT 3 COMPONENT VIDEO MONITOR OUT Y CB/PB CR/PR IN 3 4 HDMI Ver 1.1 INPUT 1 INPUT 2 INPUT 3 OUTPUT R R SR SW (AUX2) 7.1CH INPUT SBR 1 2 IN OUT IN OUT IN OUT TV DVD VCR DSS TAPE CD/CDR AUDIO DIGITAL IN OPT OUT FLASHER DIGITAL OUT REMOTE CONT. IN L SL C SBL R L R L R L AC IN R SR SW SBR PRE OUT FRONT SURROUND BACK SURROUND S. SPEAKER B SPEAKER SYSTEMS : 6-8 OHMS CENTER SWITCHED 1.25A 150W AC OUTLETS 120V 60Hz MODEL NO. SR4002 y !0 !4 o !5 i u REAR PANEL (SR5002) !1 w !2 q t r !6 VIDEO FM (75) GND AM ANTENNA L SL C L S-VIDEO TV SBL INPUT 1 DVD VCR IN VCR OUT DSS INPUT MONITOR OUT 2 Y COMPONENT INPUT 3 VIDEO MONITOR 1 OUT 2 CB/PB CR/PR Y CB/PB CR/PR Y CB/PB CR/PR IN INPUT 1 4 5 INPUT 2 HDMI Ver 1.1 INPUT 3 XM OUTPUT R R SR SW (AUX2) 7.1CH INPUT SBR MULTI. OUT TV RS-232C SPEAKER C OFF ON DVD IN OUT VCR DSS L SL C SBL R L R L IN OUT TAPE AUDIO 1 IN OUT CD/CDR 2 3 DIGITAL IN OPT OUT DIGITAL OUT REMOTE CONT. FLASHER DC IN TRIGGER R L R L AC IN FRONT B FRONT A SURROUND BACK SURROUND CENTER R SR SW SBR FRONT A OR B.CENTER. FRONT A + B : 8 OHMS PRE OUT SPEAKER C/MULTI SPEAKER SURR.SURR BACK : 6-8 OHMS SPEAKER SYSTEMS SWITCHED 1.25A 150W AC OUTLETS 120V 60Hz MODEL NO. SR5002 e y !0 !9 o !4!5 i !3 u!7!8 @0 q VIDEO IN/OUT (TV, DVD, VCR, DSS) These are the video inputs and outputs. There are 4 video inputs and 2 video outputs and each one includes both composite video and S-video configurations. Connect VCRs, DVD players, and other video components to the video inputs. The 2 video output channels can be used to be connected to video tape recorders for making recordings. w FM antenna terminal (75 ohms) Connect an external FM antenna with a coaxial cable, or a cable network FM source. t MONITOR OUT This is a monitor output and each one includes both composite video and S-video configurations. When connecting two video monitors or televisions, be aware that the OSD interface can be used with both MONITOR OUT connections. y Preamp Outputs (L, R, SL, SR, SBL, SBR, C) Jacks for L(front left), R (front right), C (Center), SL (surround left), SR (surround right), SBL (surround back left) and SBR (surround back right). Use these jacks for connection to external power amplifiers. AM antenna and ground terminals Connect the supplied AM loop antenna. Use the terminals marked "AM" and "GND". The supplied AM loop antenna will provide good AM reception in most areas. Position the loop antenna until you hear the best reception. e RS-232C (SR5002 only) The RS-232C port is to be used in conjunction with an external controller to control the operation of the SR5002 by using an external device. r COMPONENT VIDEO INPUT/ OUTPUT If your DVD player or other device has component video connectors, be sure to connect them to these component video connectors on the unit. This unit has two component video input connectors to obtain the color information (Y, CB, CR) directly from the recorded DVD signal or other video component and one component video output connector to output it directly into the matrix decoder of the display device. By sending the pure DVD component video signal directly, the DVD signal forgoes the extra processing that normally would degrade the image. The result is vastly increased image quality, with incredibly life like colors and crisp detail. When the video convert function is enabled, video and S-video images can be output to the COMPONENT MOINTOR OUT jack. u AC INLET Plug the supplied power cable into this AC INLET and then into the power outlet on the wall. This unit can be powered by 230V AC only. i AC OUTLETS Connect the AC power cable of component such as a DVD or CD player to this outlet. This outlet provides power only when this unit is turned on. Caution: • In order to avoid potential turn-off thumps, anything plugged into this outlet should be powered up before this unit is turned on. • The capacity of this AC outlet is 150W. Do not connect devices that consume electricity more than the capacity of this outlet. If the total power consumption of the connected devices exceeds the capacity, the protection circuit shuts down the power supply. o Speaker outputs terminals Seven terminals are provided for the front left, front right, front center, surround left, surround right, surround back left and surround back right speakers. Note: You can use surround back speaker terminals as M (Multiroom) SPEAKER B terminals, when you use no surround back speaker. 8