NEC UN552S User Manual English - Page 131
NEC UN552S Manual
View all NEC UN552S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 131 highlights
English CONTROL MENU NETWORK FUNCTIONS USB TOUCH POWER (Not available) EXTERNAL CONTROL PC SOURCE USB POWER CEC CEC AUTO TURN OFF AUDIO RECEIVER SEARCH DEVICE RESET Individually enable or disable the networking component for these monitor functions: DISPLAY: Enables or disables the network function for controlling the monitor remotely. When disabled, these functions do not work: External Control, Mail, Daisy chain functions, HTTP server, SNMP, Crestron, AMX, PJLink. NOTE: If you disable DISPLAY, monitor control in a daisy chain configuration is not available. Please be aware of the impact in multi-monitor installations before disabling it. COMPUTE MODULE: Enables or disables the network function for the Compute Module Interface Board only. MEDIA PLAYER: Enables or disables the network function for the Media Player only. When disabled, these functions do not work: [SHARED FOLDER SETTINGS] and [SHARED SD CARD SETTINGS]. Under APPLY, Highlight YES then press SET/POINT ZOOM button to save your selection. If you do not press SET/POINT ZOOM button when [YES] is highlighted, your selections are not saved. NOTE: To apply a firmware version update over the network, [DISPLAY] and [MEDIA PLAYER] must be enabled. When enabled, the monitor can be controlled by a device connected to the USB2 port. Select the connected device to control the monitor with. And select a device connected to USB1 (SENSOR) port which controls the monitor. AUTO: Automatically selects the PC SOURCE type. EXTERNAL PC: Select this option to use a PC when it is connected to the USB2 port. OPTION: Select this option to use an Option board. If a slot 2 type option board is not installed, OPTION will not be available as a selection. C MODULE: Select this option when a Raspberry Pi Compute Module and Interface Board is installed. If a Raspberry Pi Compute Module is not installed, C MODULE will not be available as a selection. Select [ON] to supply power to the USB CM1 (2A) port. NOTE: Power consumption by devices connected to this port depends on the USB devices. Provides CEC (Consumer Electronics Control) compatible media players, connected via HDMI, the ability to communicate and allows limited control between the device and the monitor. Only available for HDMI inputs. When [ON] is selected, the following functions are automatically activated: - When a connected CEC media device plays, the monitor will turn on and/or change to the HDMI input with the connected media device. - The monitor's wireless remote control can be used to control some of the media player device functions. The wireless remote control CEC functions are: 1 (9), 2 (4), 3 (:), 5 (