NEC UN552S User Manual English - Page 97
Hardware Issues
View all NEC UN552S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
English The image is unstable, unfocused or swimming is apparent • The signal cable should be completely attached to the computer. • Please adjust settings in the [ADJUST] of the [PICTURE MODE] by checking displayed image on the screen. • When the display mode is changed, the OSD Image Adjust settings may need to be re-adjusted. • Check the monitor and your display card with respect to compatibility and recommended signal timings. • If text looks garbled, change the video mode to noninterlaced and use a 60 Hz refresh rate. • The image may be distorted when turning the power on or changing the settings. The image of component signal is greenish • Check to see if the VGA (YPbPr) input connector is selected. The image is not properly reproduced • Use the OSD Image Adjust controls to increase or decrease the coarse adjustment. • Make sure that a supported resolution has been selected on the display card or system being used. • If in doubt, please refer to the user's manual of the display card or system to change the resolution. Selected resolution is not displayed properly • Check the Information OSD to verify the appropriate resolution has been selected. • If the resolution you set is over or under a range, "OUT of RANGE" window will appear then warn you. Please set supported resolution at the connected computer. Video contrast is either too high or too low • Check that the correct option for the VIDEO LEVEL is selected for the input signal. This only applies to video signals on the DisplayPort, HDMI, and OPTION inputs. -- Blacks are crushed and whites are clipped change the VIDEO LEVEL to RAW. Crushing blacks and clipping whites can occur when the monitor's VIDEO LEVEL is set to EXPAND while the source video signal's color levels are RGB Full (RGB 0-255), causing lost details in the shadows and highlights and the image appears overly high in contrast. -- Blacks are dark grey and whites are dull change the VIDEO LEVEL to EXPAND. Dulling blacks and whites can occur when the VIDEO LEVEL is set to RAW while the source video signal's color levels are RGB Limited (RGB 16-235), which effectively appears to prevent the monitor from obtaining its full brightness range and the image appears to be lacking in contrast. Either light vertical or horizontal stripes may appear, depending on the specific image pattern. This is not a product fault or degradation. Hardware Issues button does not respond • Unplug the power cord of the monitor from the AC outlet to turn off and reset the monitor. • Check the main Power Switch on the monitor. No Sound • Check to see if the audio cable is properly connected. • Check to see if [MUTE] is activated. Use the remote control to enable or disable the Mute function. • Check to see if [VOLUME] is set to a minimum. • Check to see if the computer supports an audio signal through DisplayPort. If unsure, contact your supplier. • When [LINE OUT] is not functioning, check to see if [SURROUND] is [ON]. • If HDMI CEC audio device is not connected, please set [AUDIO RECEIVER] to [OFF]. The Remote Control is not functioning • The batteries may be drained. Please change the batteries, then check if the remote control works. • Check that the batteries are inserted correctly. • Check that the Remote Control is pointing at the remote control sensor of the monitor. • Check the status of [IR LOCK SETTINGS]. • The remote control system may not function when direct sunlight or strong illumination strikes the remote control sensor of the monitor, or when there is an object in the path. The SCHEDULE/OFF TIMER function is not working properly • The [SCHEDULE] function will be disabled when the [OFF TIMER] is set. • If the [OFF TIMER] function is enabled and the power to the monitor is turned off when the power supply is interrupted unexpectedly, then the [OFF TIMER] will be reset. English−93