Onkyo HT-S6300 Owner Manual - Page 29

7 Use R/X to select an option, and then press ENTER. 2EQ: Auto Setup - - Review Speaker Configuration - - Subwoofer Front Center Surround Front High Surr Back Surr Back Ch Yes 40Hz TV 40Hz 100Hz 100Hz 120Hz 2ch Save Cancel The options are: ` Save: Save the calculated settings and exit Audyssey 2EQ® Room Correction and Speaker Setup. ` Cancel: Cancel Audyssey 2EQ Room Correction and Speaker Setup. Note • You can view the calculated settings for the speaker configuration, speaker distances, and speaker levels by using F/S. 8 Disconnect the speaker setup microphone. Note • When Audyssey 2EQ Room Correction and Speaker Setup is complete, the "Equalizer" will be set to "Audyssey" (➔ 42). The Audyssey indicator will light (➔ 9). • You can cancel Audyssey 2EQ Room Correction and Speaker Setup at any point in this procedure simply by disconnecting the setup microphone. • Do not connect or disconnect any speakers during Audyssey 2EQ Room Correction and Speaker Setup. • If the AV receiver is muted, it will be unmuted automatically when Audyssey 2EQ Room Correction and Speaker Setup starts. • Changes to the room after Audyssey 2EQ Room Correction and Speaker Setup requires you run Audyssey 2EQ Room Correction and Speaker Setup again, as room EQ characteristics may have changed. Error Messages While Audyssey 2EQ Room Correction and Speaker Setup is in progress, one of the error messages below may appear. The options are: ` Retry: Try again. ` Cancel: Cancel Audyssey 2EQ Room Correction and Speaker Setup. • Ambient noise is too high. The background noise is too loud. Remove the source of the noise and try again. • Speaker Matching Error! The number of speakers detected was different from that of the first measurement. Check the speaker connection. • Writing Error! This message appears if saving fails. Try saving again. If this message appears after 2 or 3 attempts, contact your Onkyo dealer. • Speaker Detect Error This message appears if a speaker is not detected. "No" means that no speaker was detected. Tip • See "Speaker Configuration" for appropriate settings (➔ 16). Changing the Speaker Settings Manually You can manually make changes to the settings found during Audyssey 2EQ Room Correction and Speaker Setup. See also: • "Speaker Configuration" (➔ 41) • "Speaker Distance" (➔ 41) • "Level Calibration" (➔ 42) • "Equalizer Settings" (➔ 42) Using a Powered Subwoofer If you're using a powered subwoofer and it outputs very low-frequency sound at a low volume level, it may not be detected by Audyssey 2EQ Room Correction and Speaker Setup. If the "Subwoofer" appears on the "Review Speaker Configuration" screen as "No", increase the subwoofer's volume to the half-way point, set it to its highest crossover frequency, and then try running Audyssey 2EQ Room Correction and Speaker Setup again. Note that if the volume is set too high and the sound distorts, detection issues may occur, so use an appropriate volume level. 2EQ: Auto Setup Ambient noise is too high. Retry Cancel Error message En 29