Panasonic SABT300 Blu-ray Disc Home Theater Sound System - Page 7

Getting started Assembling the speakers [BT300] \BT303\ : Front speakers Preparation ≥To prevent damage or scratches, lay down a soft cloth and perform assembly on it. ≥For assembly, use a Phillips-head screwdriver (not included). ≥For optional wall mount, refer to page 46. Make sure you have all the indicated components before starting assembly, setup, and connection. Keep the screws out of reach of children to prevent swallowing. 2 Front speakers 1 2 Stands (with cables) 2 Bases 8 Screws Slide into the groove. Tighten securely. 2 2 Insert the wire fully. : White : Blue Position the cable between the ridges. Push! Press into the groove. 1 Leave about 120 mm (423/32) Tighten securely. Speaker assembly option Thread the speaker cable through the base. Attach the speaker. Leave about 120 mm (423/32) You can remove and use the cable from the stand. To reattach the cable, refer to page 46. Insert the wire fully. : White : Blue Push! Press into the groove. Tighten securely. Slide into the groove. Do Not NOTE ≥Be careful not to cross (short-circuit) or reverse the polarity of the speaker wires as doing so may damage the speakers. Preventing the front speakers from falling ≥You will need to obtain the appropriate screw eyes to match the walls or pillars to which they are going to be fastened. ≥Consult a qualified housing contractor concerning the appropriate procedure when attaching to a concrete wall or a surface that may not have strong enough support. Improper attachment may result in damage to the wall or speakers. e.g. Caution String (not included) Thread from the wall to the speaker and tie tightly. ≥Do not stand on the base. Be cautious when children are near. e.g. Screw eye (not included) Rear of the speaker Wall Approx. 150 mm (529/32) DO NOT RQT9508 7