Pfaff hobby 420 Owner's Manual - Page 42
Pfaff hobby 420 Manual
View all Pfaff hobby 420 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
4 Nahtreil3verschlufl Maschinen-Einstellung sIehe Seite 36. So wird der Rei6verschluB vorbereitet und angelegt: Die Schlitzkanten bugeln. Linke Naht breite nach aul3en drehen (Abb. S). Linke geoffnete Reil3verschlul3seite, wie Abb. T zeigt, auflegen. Die Reil3verschlu6zähne stehen etwas über die gebügelte Kante. Die Steppnaht verläutt in der gebugelten Kante. Ndhfu6 in die Mitte schieben, so daB die Nadel in die mittlere Einstichsoffnung einsticht. Die Reil3verschlu6zähne laufen in der linken Fuhrungsrille des Ful3es (Abb. U). Zu Beginn der Naht die Zähne zum Einführen in die Fuhrungsrille etwas aufrichten. Naht bis zum Ende nàhen und vernähen. ReiBverschluB schlief3en. Zweite Reil3verschlul3seite am Nahtanfang fesistecken (Abb. V) und ReiBverschluB öffnen. Die rechte Nahtbreite mit dem ReiBver schlul3band nach auBen drehen, zuvor die Nadel entfernen und, wie Abb. W zeigt, das Reil3verschlul3band auf der Naht feststecken. Die ReiBverschluB zähne aufen nun in der rechten Fuhrungsrille des FuBes (Abb, X). ReiB verschlult fertig einnãhen. Das ReiBver schluBband ful3breit auf die Naht steppen. Die ReiBverschlul3zähne laufen auBen am Fuhrungssteg entlang (Abb. Y). Seam-like zip fastener For machine setting see page 36 How the zipper is prepared and inserted: Press the edges of the closure. Fold out the left seam allowance (Fig. S). Place the left side of the open zip in position so that its teeth protrude a little beyond the pressed edge (Fig. T). The seam is sewn along this edge. Move the zipper foot to the middle so that the needle stitches into the middle opening. The zip teeth run into the left guiding groove in the foot (Fig. U). At the beginning of the seam lift up the teeth a little to feed them into the guiding groove. Sew the seam to the end and secure it. Close zip. Pin other side of zip to material at beginning of seam (Fig. V). Open zip. Remove the pin, turn out the right seam allowance with the zip tape, and pin the latter to the fabric, as shown in Fig. W. The zip teeth now run into the right guiding groove in the foot (Fig. X). Finish sewing the zip. Now sew down the zip tape letting the zip teeth run along the guiding edge of the foot (Fig. Y).