Pioneer 607CMX Technical Manual - Page 125
Color Decoding Setting
UPC - 012562824413
View all Pioneer 607CMX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 125 highlights
[Applicable only when a PDA-5003/PDA-5004 is installed] Menu Mode 7) Color Decoding Setting When a video signal is input at INPUT1, INPUT2 and INPUT5, it corresponds to an RGB and component video signal. This setting must comply with the connected device. The setting should be performed as shown below for INPUT1, INPUT2, and INPUT5. (Example) • When reproducing an RGB signal: Set to 'COLOR DECODING: RGB'. • For reproduction from a DVD player: Set to 'COLOR DECODING: COMPONENT1'. Settable condition: Factory setting: INPUT1, INPUT2, INPUT5 When a video signal (signal other than a PC signal) is input For 525i, 525p, 625i, 625p signal input: COMPONENT1 For 750p, 1125i, 1125p, 1250p signal input: COMPONENT2 1 Select 'SETUP'. 2 Place the cursor over 'COLOR DECODING' then press the [SET] button to change the setting. Each time the [SET] button is pressed, the setting changes as shown below. 3 RGB 3 COMPONENT1 COMPONENT22 Set 'COLOR DECODING' as follows. Please take care when assigning settings. Incorrect settings can adversely affect the Plasma Display. Connected component SETUP Component video output of Y/Cb/Cr format. For example, DVD player, etc. Component video output of Y/Pb/Pr format. For example, digital tuner, etc. RGB video output of a video deck etc., with RGB output DVI video output of an AV component with DVI output port RGB video output of a PC COLOR DECODING COMP.1 COMP.2 RGB RGB Not supported Screen 2 MENU PICTURE SCREEN C O L O R T E M P. AUTO POWER OFF DNR MPEG NR CTI PURECINEMA COLOR DECODING COLOR SYSTEM SIGNAL FORMAT SET CHANGE INPUT1 SETUP OPTION :MIDDLE :DISABLE :MIDDLE :LOW :ON :OFF :RGB :AUTO MENU EXIT 125