Pioneer 607CMX Technical Manual - Page 66
Caution
UPC - 012562824413
View all Pioneer 607CMX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
Table Top Stand: PDK-TS26 4.4.4 Stand assembling 1 Remove the cardboard and accessories (screws, operating instructions) from the box. ¶ View of packaged items Cardboard 4 Tear off the protective sheets covering the feet from their perforated lines so you can see their attachments. ¶ Place them so the attachments are towards you. Shock absorbing boxes Shock absorbing boxes Screws / Securing brackets Operating instructions Attachment Perforated line Bar (Covered with protective sheets) Toward you Feet (Covered with protective sheets) 2 Remove the bar then remove the shock absorbing boxes from the left and right sides. 5 Take the protective sheet off the bar that you removed in step 2, insert the bar aligned with the guide pins of the feet. If the bar and guide pins on the feet do not match, the feet and bar are in reversed position. Reverse the left and right ends of the bar and align it with the pins again. Then tighten it with the included stand assembly screws (M4 × 10 mm). Guide pins 3 Remove the two boxes containing the feet, and set them upside down on the floor. Caution Tighten the screws firmly. The stand may fall over causing injuries. 6 Pick up the boxes containing the feet, turn them over again, and put them back on the floor. Then take the box out of its stand. 66