Pioneer 607CMX Technical Manual - Page 67

Table Top Stand: PDK-TS26 4.4.5 Attaching the Stand to the Plasma Display 1 Attaching Plasma Display to stand. ¶ Make sure that the stand and Plasma Display are properly aligned together, and then place the Plasma Display onto the stand. ¶ Lift up both ends of the Plasma Display then engage the holes on the bottom of the display with the stand. 2 Fixing Plasma Display to stand. 1. While pulling the upper part of the Plasma Display towards your body, screw the monitor attachment screws (M6 × 50 mm) firmly into place (four locations). 2. Once the Plasma Display has been attached, rock the monitor gently to make sure that there is no looseness and that the screws have been screwed tightly into place. 2-2 Monitor attachment screws 2-1 Caution ¶ Once the Plasma Display has been placed onto the stand, immediately insert the screws and tighten them to fix the monitor into place. Failing to tighten the screws could result in the monitor falling over, which might in turn result in bodily injury. ¶ Because the Plasma Display is heavy and has a high center of gravity, installation by one or two people is hazardous. Please employ three or more people during installation, being sure to hold the handle on the back as well as the lower portion of the monitor, while supporting its top and bottom. After attachment, take measures to prevent it from falling over. Attach the securing brackets and screws provided with the stand to the Plasma Display in the locations indicated in the accompanying diagram, and then use separate commercially available screws (eye screw) and wires or some other similar item of sufficient strength to secure the Plasma Display into place against a wall, pillar, or some other surface or otherwise use the holes located at the rear of the stand to fix the stand into place. (Note that these brackets and screws are not used when using a separately sold ceiling attachment unit or wall attachment unit.) Be sure to take care of the securing wires when moving the stand or Plasma Display. Note that the wires and screws needed to secure the Plasma Display against a wall or pillar or against the stand are not provided with the stand, and that the proper items must be purchased separately in accordance with the type of object or surface against which the monitor is to be secured. Securing brackets Separately purchased screws 67