Pioneer 607CMX Technical Manual - Page 154

Integrator Mode 10) SIDE MASK Setting This mode is for adjusting the brightness of the no-image section around the screen when the screen size is '4:3' etc. When performing adjustments, pay attention to the brightness balance between the displayed signal and that of the adjacent sets. Factory setting: R. LEVEL, G. LEVEL, B. LEVEL ...... 80 AUTO SIDE MASK OFF 1 Enter the integrator mode. (Refer to section 5.4.1, "About the Integrator Mode" (pg. 142).) 2 Select 'OPTION'. 3 Place the cursor on 'SIDE MASK' then press the [SET] button. Screen 3 I N T E G R ATO R INPUT1 PICTURE SCREEN PROGRAM T I MER SCREEN MASK S I DE MASK V I D E O WAL L BAU D R AT E I D NO. SE T SETUP OPTION : GREEN : 3 8 4 0 0BPS : 01H SET ENTER MENU EXIT 4 Place the cursor on a level (R. LEVEL, G. LEVEL, B. LEVEL) then adjust the setting using the [2/3] buttons. Each item: 0 to 255 (initial value: 80) Screen 4 SIDE MASK R. LEVEL G. LEVEL B . LEVEL AUTO SIDE MASK D E FAU LT RETURN : 80 : 80 : 80 : OFF SET MENU EXIT 5 Change the setting by pressing the 2/3 buttons to move the cursor to the 'AUTO SIDE MASK'. Each time a 2/3 button is pressed, the setting changes as shown below. 3 ON OFF 2 ON ....... To reduce burning when a black band appears at both edges of a 4:3 image displayed on a 16:9 screen, a preset side mask is displayed. OFF ..... It does not operate. Screen 5 SIDE MASK R. LEVEL G. LEVEL B . LEVEL AUTO SIDE MASK D E FAU LT RETURN : 80 : 80 : 80 : OFF SET MENU EXIT Note • It is only effective during one screen display. • It is only effective during INPUT2 and INPUT5 color signal. • Compatible signals: 1080i, 720p, 1080p • It takes about five seconds until display starts. If it is a dark image, it may take even longer. • As the black band on a 16/9 screen disappears, the preset side mask also disappears. 154 • This function does not operate for patterned or for colored bands.