Pioneer 607CMX Technical Manual - Page 126
Color System Setting
UPC - 012562824413
View all Pioneer 607CMX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 126 highlights
Menu Mode [Applicable only when a PDA-5003/PDA-5004 is installed] 8) Color System Setting INPUT3 and INPUT4 correspond to and automatically determine the various TV systems used in countries around the world. Normally, this setting is set to 'COLOR SYSTEM: AUTO (Auto detection)', however, in the case of VTR signals with repeated dubbings, proper reproduction of the signal may not be possible (no color, etc.). In this case, the setting needs to correspond to the input signal as follows. The setting should be performed for INPUT3 and INPUT4. • For NTSC signal input: Set 'COLOR SYSTEM: NTSC'. • For PAL signal input: Set 'COLOR SYSTEM: PAL'. • For SECAM signal input: Set 'COLOR SYSTEM: SECAM'. • For 4.43NTSC signal input: Set 'COLOR SYSTEM: 4.43NTSC'. • For PAL-M signal input: Set 'COLOR SYSTEM: PAL M'. • For PAL-N signal input: Set 'COLOR SYSTEM: PAL N'. By fixing the settings when the input signal is already known in advanced, it is possible to perform smooth image processing and to prevent signal confusion. Settable condition: INPUT3, INPUT4 Factory setting: INPUT3: AUTO INPUT4: AUTO 1 Select 'SETUP'. 2 Place the cursor over 'COLOR SYSTEM' then press the [SET] button to change the setting. Each time the [SET] button is pressed, the setting changes as shown below. 3 AUTO 3 NTSC 3 4.43NTSC 3 PAL SECAM 2 PAL M 2 PAL N 2 Screen 2 MENU PICTURE SCREEN C O L O R T E M P. AUTO POWER OFF DNR MPEG NR CTI PURECINEMA COLOR DECODING COLOR SYSTEM SIGNAL FORMAT SET ENTER INPUT1 SETUP OPTION :MIDDLE :DISABLE :MIDDLE :LOW :ON :OFF :RGB :AUTO MENU EXIT 126