Pioneer 607CMX Technical Manual - Page 71
Installing the Plasma Display
UPC - 012562824413
View all Pioneer 607CMX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
Wall Mount Unit: PDK-WM03 3) Installing the Plasma Display With the display metal fitting already attached to the Plasma Display, attach the plasma display to the hung on wall unit. 1 Hang the top hooks of the left and right display metal fittings on the groove in the hung on wall unit. Top hook 2 With the top hooks in the groove, lift the Plasma Display straight up for about 1 cm, and when you cannot raise it any further, push the bottom edge of the Plasma Display to the wall and hang it with the bottom hooks. Bottom hook Note If the bottom of the Plasma Display does not move when you try to pull it towards you, it is correctly installed. 2 Tighten the anchor screws on the top of the left and right display metal fitting with a driver. Anchor screw Note To install it at a high location where you cannot lift it manually, you can install it by suspending the eyebolts on the top hardware of the display with a crane etc.. When doing this, make sure that the eyebolt is not loose. 71