Pioneer 607CMX Technical Manual - Page 156

Integrator Mode 11) VIDEO WALL Setting Use this feature to configure a four panel to 25-panel video wall. Note This setting is adjusted when the screen size is full display. It is not correctly displayed in other screen sizes. (See pg. 89) Factory setting: DIVIDER OFF POSITION TYPE NORMAL AUTO ID OFF P.ON DELAY OFF ABL LINK OFF [Setting Method] 7 Setting the ID NO. SET Refer to "13) Assigning an ID" (pg. 161) 7 Setting the screen divider 1 Enter the integrator mode. (Refer to section 5.4.1, "About the Integrator Mode" (pg. 142).) 2 Select 'OPTION'. 3 Place the cursor on 'VIDEO WALL' then press the [SET] button. Screen 3 I N T E G R ATO R INPUT1 PICTURE SCREEN PROGRAM T I MER SCREEN MASK S I DE MASK V I D E O WAL L BAU D R AT E I D NO. SE T SETUP OPTION : GREEN : 3 8 4 0 0BPS : 01H SET ENTER MENU EXIT 4 Place the cursor on 'DIVIDER'. Screen 4, 5 5 Press the [2/3] buttons then press the [SET] button to change the settings. Each time the [2/3] buttons are pressed, the setting changes as shown below. 3 3 3 3 3 OFF 3 1 3 2x2 3 3x3 3 5x5 3 4x4 3 3 OFF, 1 ..... Screen division is not performed. Set it to '1' to set an ABL link without dividing the screen. 2x2 .......... Four panel video wall 3x3 .......... Nine panel video wall 4x4 .......... 16-panel video wall 5x5 .......... 25-panel video wall VIDEO WALL D I V I DER POS I T I ON T YPE AUTO I D P . O N D E L AY ABL L I NK RETURN : OFF : NORMAL : OFF : OFF SET MENU EXIT Note • When 4 to 25 screens have been selected, set POSITION. • When a problem occurs while programming the video wall settings, externally power down the video wall panels. 156