Pioneer 607CMX Technical Manual - Page 159

Integrator Mode (When 16 and 25 screen Video Walls) 3 OFF 2 2 MODE2 2 MODE1 2 2 OFF → MODE1 (after approx. one second)* → MODE2 (after approx. two seconds)* * The seconds shown above are yardstick targets; errors may occur. Shift and set the power on timing by grouping OFF, MODE1, and MODE2. 7 Setting the ABL LINK This option synchronizes the screen brightness on the multiple displays that form a Video Wall. Apply the AUTO ID function the select a screen divider option (other than OFF). ~ Place the cursor on 'ABL LINK' then press the [2/3] buttons to change the settings. Each time a [2/3] button is pressed, the setting changes as shown below. 3 ON 2 3 OFF 2 [Setting the ABL LINK] ON Brightness of each screen on the video wall is the same (available for four panel and nine panel video walls only). OFF ......... Brightness of the screens depends on the setting of each display. [Connecting four displays] When this option is 'ON', connect the four displays according to the POSITION sequence numbers in the figure on the right with the combination cable (Mini-DIN, 6 pin). If the screen division or POSITION has changed, the ABL link automatically turns off. Screen ~ VIDEO WALL D I V I DER POS I T I ON T YPE AUTO I D P . O N D E L AY ABL L I NK RETURN : OFF : NORMAL : OFF : OFF SET MENU EXIT COMBINATION IN No.1 No.2 No.4 No.3 Display 1 COMBINATION OUT COMBINATION IN No.1 No.2 No.4 No.3 COMBINATION OUT Display 2 COMBINATION OUT No.1 No.2 No.4 No.3 Display 3 COMBINATION OUT COMBINATION IN No.1 No.2 No.4 No.3 COMBINATION IN Display 4 Note • Connect in the same way for a nine panel video wall. • In case of a 16 or 25 panel video wall, it is recommended that it be used with the power saving setting for the entire screen changed to MODE1. The 'VIDEO WALL' settings are common for all inputs. 159