Pioneer 607CMX Technical Manual - Page 180

Integrator Mode 24) REPEAT TIMER Setting When two input modes have been set, they are displayed alternatively. This can be used to set one screen, two screens, or video wall. Factory setting: REPEAT TIMER SINGLE 1. WORK TIME 00H10M INPUT MODE INPUT1 2. WORK TIME 00H10M INPUT MODE INPUT2 1 Enter the integrator mode. (Refer to section 5.4.1, "About the Integrator Mode" (pg. 142).) 2 Select 'OPTION'. 3 3 Place the cursor on 'REPEAT TIMER' then press the [SET] button. 4 Place the cursor on 'REPEAT TIMER' then use the [2/3] buttons to change the settings. Each time a [2/3] button is pressed, the setting changes as shown below. 3 VIDEO WALL 3 MULTI 3 SINGLE VIDEO WALL ..... It operates REPEAT TIMER during video wall. MULTI It operates REPEAT TIMER during two screen display. SINGLE It operates REPEAT TIMER during single screen display. 3 3 Screen 4 R E P E AT T I M E R R E P E AT T I M E R 1 WORK T I ME INPUT MODE : SINGLE : 0 0H1 0M : I NPUT 1 2 WORK T I ME INPUT MODE SET SET : 0 0H1 0M : I NPUT2 MENU EXIT Each item is set as follows. Select the item with the [5/∞] buttons and change its setting with the [2/3] buttons. 7 Setting the single screen REPEAT TIMER • WORK TIME .......... It sets the display time in a range from one minute to 24 hours. • INPUT MODE ........ It sets the signal that is displayed INPUT1 ⇔ INPUT2 Note Perform this operation after turning the setting of DIVIDER in "5.4.3 Adjustments and setting in the Integrator Mode: 11) VIDEO WALL Setting (pg. 156)" to OFF. 180