Pioneer PDP-425CMX User Manual - Page 29

English Automatic power-off (POWER MANAGEMENT) This display is equipped with [POWER MGT.] function, which allows the unit to automatically switch to standby mode when no sync signal is detected. (A warning message is displayed before this function operates.) Note Always turn off the Plasma Display's main power switch when not using the display for extended periods of time. INPUT MENU 2/3 SET Remote control unit STANDBY/ON DISPLAY MENU / SET INPUT SCREEN SIZE - VOL + MENU SET INPUT 2/3 Main unit operating panel 1 Press the MENU button to display the menu screen. MENU PICTURE SCREEN CONTRAST BRIGHTNESS H.ENHANCE V. E N H A N C E SETUP : : : : INPUT1 OPTION 0 0 0 0 PICTURE RESET SET ENTER MENU EXIT Operation 2 Use the 2/3 buttons to select [SETUP]. MENU PICTURE SCREEN P O W E R M G T. SIGNAL FORMAT SETUP :OFF INPUT1 OPTION SET CHANGE MENU EXIT 3 Press the SET button to confirm selection of [POWER MGT.]. The factory default setting is [OFF]. Each time the button is pressed, the setting alternates as follows: 3 OFF ON 2 ÷ OFF ..... The display will continue in operating mode, regardless of the presence/absence of an input sync signal. ÷ ON ....... If a sync signal is not detected, a warning message is first displayed for 8 seconds, after which the display automatically enters the standby mode, and the STANDBY/ON indicator flashes green. If a sync signal is input again later, the Plasma Display automatically returns to normal operating mode (*1). *1. Except when input signal is G ON SYNC or composite SYNC 4 When the setup is finished, press the MENU button to exit the menu screen. Note The [POWER MGT.] function must be set individually for each input (INPUT1 or INPUT2). To return to operating mode: To return to normal operation from the [POWER MGT.] function's standby mode, either operate your computer, or press the INPUT button. Operation 23 En