Pioneer VSX-35TX Owner's Manual - Page 12

Connecting Your Equipment Audio Components To begin set up connect your audio components to the jacks as shown below. These are all analog connections and your analog audio components (turntable, cassette deck) use these jacks. Remember that for components you want to record with you need to hook up four plugs (a set of stereo ins and a set of stereo outs), but for components that only play (like a turntable) you only need to hook up one set of stereo plugs (two plugs). To use DTS or Dolby Digital surround sound features you must hook up your digital components to the digital inputs (see p. 13). We also recommend hooking up your digital components to analog audio jacks. If you want to record to/from digital components (like an CD-R) to/from analog components you must hook up your digital equipment with these analog connections. See p.13 & 15 for more on digital connections. Before making or changing the connections, switch off the power and disconnect the power cord from the AC wall outlet. *The arrows indicate the direction of the audio signal. ANALOG OUTPUT (PLAY) INPUT (REC) L L R R ANALOG OUTPUT (PLAY) INPUT (REC) L L R R Recorder 1 (CD-R/Tape) Recorder 2 ANALOG OUTPUT L R CD player Please don't hook up any other component to the PHONO jacks other than a turntable. It could damage the equipment. If your turntable has a built-in amplifier please hook it up to an input other than the PHONO. Turntable If your turntable has a ground wire, connect it to the SIGNAL GND terminal. 7 Analog audio/video cords Use audio/video cords (not supplied) to make analog audio and video connections. L Connect red plugs to R (right) and white plugs to L (left). R Be sure to insert completely. Cassette deck placement Depending on where the cassette deck is placed, noise may occur during playback of your cassette deck which is caused by leakage flux from the transformer in the receiver. If you experience noise, move the cassette deck farther away from the receiver. 12 7 Coaxial cords/Optical cables Commercially available digital audio coaxial cords (standard video cords can also be used) or optical cables (not supplied) are used to connect digital components to this receiver. When you use optical digital input or output terminals, pull off the caps and insert the plugs. Be sure to insert completely. Coaxial cord Optical cable (or standard video cord)