Pioneer VSX-35TX Owner's Manual - Page 59

Remote Control of Other Components 4 Press the MULTI CONTROL button for the component you want to control. Î S0URCE MULTI OPERATION USE SETUP SYSTEM OFF RECEIVER The selected button lights steadily and the first manufacturer (and preset code(s)) appear on your TV screen. 6 7 DVD/LD CD CLASS TV/SAT VCR 1/ DVR VCR2 MULTI CONTROL CD-R/ TAPE 1 TUNER TV CONT MPX BAND DIRECT ACCESS ¶ 7 - + TUNING 1¡ DTV ON/OFF DTV MENU 3 8 - + STATION 4¢ - + CHANNEL 123 456 7 GUIDE +10 + TV VOL - 8 0 TV TV CONTROL TV FUNC 9 EXIT ENTER DISC + VOLUME - REMOTE SETUP INPUT ATT SYSTEM SETUP EFFECT/ CH SEL DIGITAL NR MENU + ENTER - MUTE FUNCTION SIGNAL SELECT MIDNIGHT LIGHT MULTI CH INPUT THX DSP /DTS ADVANCED STEREO/ DIRECT STANDARD 4 P r es e t Reca l l 1Se l ec t Func t i on 2Se l ec t Pr od uc t s [ ] 3 I n p u t I D CODE [ TAPE ] [ MARANT Z [ 821 [ Pa ge 1 / 12 ] ] ] EX I T Remo t e S e t u p 5 Press the 2¥3 buttons to choose the function and then press the 5¥∞ buttons repeatedly to display the name of the component's manufacturer. 5 Most manufacturers have been programmed into the receiver, but if your component is made by a small or relatively unknown manufacturer you may not be able to find it. 6 Point the remote toward the component to be controlled, enter the 3 digit setup code. AV PRE-PROGRAMMED AND LEARNING REMOTE CONTROL UNIT When you enter the setup code, the remote emits a power ON/ OFF signal. If the component turns ON or OFF, you have entered the proper code. If the component does not turn ON or OFF and there is more than one setup code, try inputting another code (starting again from step 4). Some manufacturers use several sets of remote control signals and the first code may not correspond to your component. Repeat steps 4 through 6 to assign preset codes for as many components as necessary. If you can't get your component to respond to any of the codes you can still program the component into the remote control using the procedure in the next section. memo The codes for are listed in the back of the manual on page 88. In this list the DVR codes are listed under the DVD and the VCR section, the DAT codes are listed under the MD section and the SAT codes are listed under the STB section. 7 Press the REMOTE SETUP button to exit the preset recall setup mode. The remote control and TV return to their previous operation modes. • When you're done setting up, remember to set the slide switch back to USE. • To erase all the preset codes see p.78 OPERATION 59