Pioneer VSX-35TX Owner's Manual - Page 58

Remote Control of Other Components Setting Up the Remote Control to Control Other Components In addition to controlling the receiver, the supplied remote control can operate your other components (VCR, TV, LD, CD, etc.) after you program it to do so. In this way, instead of fumbling with many different controls and buttons, you only need to use one remote control. If your component(s) are listed in the remote control's memory, simply follow the steps below. If your component(s) are not listed, or if you want the remote to learn additional operations, you can use the learning mode to input the information from the remote controls supplied with your other components. Recalling Preset Codes The following steps show you how to recall preset codes stored in the remote control. Once a preset code is recalled and the component assigned, you can use this remote to easily operate the component. See "Preset Code List" on p. 88 for the components and manufacturers available. 3 2,3 Î S0URCE MULTI OPERATION USE SETUP SYSTEM OFF RECEIVER DVD/LD CD CLASS TV/SAT VCR 1/ DVR VCR2 MULTI CONTROL CD-R/ TAPE 1 TUNER TV CONT MPX BAND DIRECT ACCESS ¶ 7 - + TUNING 1¡ DTV ON/OFF DTV MENU 3 8 - + STATION 4¢ - + CHANNEL 123 456 7 GUIDE +10 + TV VOL - 8 0 TV TV CONTROL TV FUNC 9 EXIT ENTER DISC + VOLUME - REMOTE SETUP INPUT ATT SYSTEM SETUP EFFECT/ CH SEL DIGITAL NR MENU + ENTER - MUTE FUNCTION SIGNAL SELECT MIDNIGHT LIGHT MULTI CH INPUT THX DSP STEREO/ DIRECT /DTS ADVANCED STANDARD AV PRE-PROGRAMMED AND LEARNING REMOTE CONTROL UNIT 1 Set the remote control slide switch to 1 SETUP. Also make sure that your TV is on and set to the receiver. 2 Press the REMOTE SETUP (INPUT ATT) button. The REMOTE SET UP menu appears on your TV screen. S e l e c t R emo t e Se t u p Mo d e Remo t e Se t u p +1 Pr e se t Rec a l l Remo t e Se t u p + 2 Lea r n i ng Remo t e Se t u p + 3 Mu l t i - Op e r a t i o n Remo t e Se t u p + 4 D i r ec t Func t i on You have four setup options: 1 Preset Recall 2 Learning 3 Multi Operation (See p. 73) 4 Direct Function (See p. 76) Preset Recall and Learning are the two modes that teach the remote control to operate your other components. It's easiest to start with Preset Recall and, if setup isn't possible for certain components, move on to the Learning mode. 3 Press the REMOTE SETUP button and 1 at the same time to select the preset recall setup mode. All the MULTI CONTROL buttons (except the TUNER button) start to blink. To cancel the preset recall setup mode press REMOTE SET UP. 58