Sony FWDS42H1 Operating Instructions - Page 59

Remote Control Button Description 1 POWER ON switch Press to turn the display on. Operate when the main power switch on the backside of the display is "ON." 2 DVI button Press to select the signal input to the DVI port. 3 S VIDEO button Press to select the signal input to the S VIDEO IN connector from a piece of video equipment. 4 VIDEO button Press to select the signal input to the VIDEO IN connector from a piece of video equipment. 5 PICTURE button Selects "Picture Mode". Each press toggles between "Vivid", "Standard", "Custom", "Conference", and "TC Control". 6 F/f/G/g/ buttons The F/f/G/g buttons move the menu cursor and set values, etc. Pressing sets the selected menu or setting items. In the "PAP" mode, you can switch the Picture and Picture setting. See page 16. 7 button Press to change the aspect ratio. See page 15. 8 MENU button Press to show menus. Press again to hide them. See page 21. GB Notes • The 5 button and button have a tactile dot. Use the tactile dot as a reference when operating the display. • Insert two size AA (R6) batteries (supplied) by matching the 3 and # on the batteries to the diagram inside the remote control's battery compartment. Caution Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. When you dispose of the battery, you must obey the law in the relative area or country. Push and slide to open , 13 GB